product description

Pure water-based protective coating, one-component, the main component is high-grade acrylic emulsion. It has excellent weather resistance, water resistance and scrub resistance. It is organic-free, non-toxic, non-polluting, non-flammable and non-explosive. It can be diluted with water and cleaned and coated with water. It is an environmentally friendly coating.

Use

Widely used in housing, construction, road teeth (shoulders or curbs) and coating protection on the outer surface of the bridge.

Features

The environmentally-friendly water-based paint has better construction performance, easy brushing, strong sag resistance, good leveling, economical cost, low coating cost per unit area, strong adhesion and good construction tolerance.

Technical Parameters

1. Coating rate: the actual painting area will vary depending on the substrate conditions.

2. washable number: > 6000 times.

3. Dilution ratio: Paint: water = 100:0-20 (weight ratio).

Optimum construction process

1. Clean, dry and strong base.

2. Use cement putty to smooth the base surface.

3. Brush 1-2 times BA-30W waterborne epoxy primer.

4. use this product to dilute and mix thoroughly, brush 2-3 times, you can achieve the best results.

Technical requirements and surface treatment

The surface of the object to be coated should be thoroughly clean, clean and dry, free from foreign matter, and the concrete strength should be above C25. The wall has a moisture content of less than 15% and a pH of less than 10.

Construction Conditions

The ambient temperature is ≥10 °C, the humidity is ≤85%, and the surface temperature of the construction workpiece is greater than the dew point temperature of 3 °C.

Precautions

It is forbidden to work in rainy days or excessively humid weather to maintain the air circulation in the construction environment; excessive dilution of water will increase the risk of painting, and it is easy to produce problems such as insufficient hiding power and insufficient film film, which will eventually reduce the overall performance of the coating film. Too thick, it is recommended to have a dry film thickness of 30 μm.